Cisco AS5350XM

Getting Started
2
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
Cisco AS5350XM or Cisco AS5400XM with AS54-DFC-CT3
To use the setup script on the gateway configuring an AS54-DFC-CT3 trunk card and five
AS54-DFC-108NP universal port cards, take the following steps.
Step 1 Power up the gateway. The power switch is on the rear panel, at the upper right corner near the power
cord, as shown in Figure 6.
Messages begin to appear in your terminal emulation program window.
Figure 6 Power Switch Location
Caution Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are
interpreted as the first command typed when the messages stop, which might cause you to power cycle
the gateway and start over. It takes a few minutes for the messages to stop.
The messages look similar to the following display.
Note The displayed messages depend on the Cisco IOS software release and feature set you selected. The
screen displays in this section are for reference only and might not exactly reflect the messages on your
console.
System Bootstrap, Version 12.3(12r)PI6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2004 by cisco Systems, Inc.
AS5400XM platform with 524288 Kbytes of main memory
Self decompressing the image :
##########################################################################################
##########################################################################################
################################ [OK]
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
31623
An AS54-DFC-CT3
Power switch
An AS54-DFC-108NP