Cisco AS5350XM - Page 54

Verifying Basic Setup
Displaying Component Status Using the Health Monitor
10
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide
CPU% per hour (last 72 hours)
* = maximum CPU% # = average CPU%
If you see high utilization numbers in the top line of the output, for example over 50 percent, inspect the
columns 5Sec, 1Min, and 5Min. Find the process that uses the most CPU power.
Displaying Component Status Using the Health Monitor
The health monitor allows you to see the status of different components of your universal gateway.
The show health-monitor summary command shows the status of the following components:
• Chassis: Power supply, temperature, fans
• Memory: Processor, I/O memory
• Feature cards
The show health-monitor summary command provides high-level component status.
The show health-monitor command shows more details, such as the status of subcomponents.
The following example shows the display output of the show health-monitor command:
AS5400# show health-monitor
Chassis:
Power Supply Failure
Redundant Power System is present.
PS Input Voltage status: failure
PS Output Voltage status: failure
PS Fan status: normal
PS Thermal status: normal
PS OverVoltage status: normal
Temperature OK
Fans OK
Memory:
Free Memory processor OK
Memory Fragmentation Processor OK
Free Memory I/O OK
Memory Fragmentation I/O OK
Detailed summary:
Head Total(b) Used(b) Free(b) Lowest(b) Largest(b)
Processor 62EC07E0 219412512 67221920 152190592 142181548 139874020
I/O 40000000 67110380 46387964 20722416 20722416 20706928
DFC's:
Slot 1 (NP108 DFC) OK
Slot 2 (NP108 DFC) OK
Slot 3 (NP108 DFC) OK
Slot 4 (NP60 DFC) OK
Slot 5 (NP108 DFC) OK, 1 SPE's BAD
Slot 7 (CT3 DFC) OK
AS5400#
AS5400#
AS5400#
AS5400#
AS5400#show health-monitor summ
AS5400#show health-monitor summary ?
| Output modifiers
<cr>
The following example shows the display output of the show health-monitor summary command: