Cisco ASA 5508-X Easy Setup Guide

To configure the ASA, use the Cisco Adaptive Security Device Manager (ASDM).
Follow these steps to download the Cisco ASDM from the ASA and install it to your
PC.
1
2
1
Launch a Web browser PC
and enter the IP address

https://192.168.1.1

into the address bar, then
press Enter key.
Depending on your environ-
ment, the security certificate
page appears.
2
Click
［
Continue to this
website (not recommend-
ed)
］
.
The Cisco ASDM web page ap-
pears.
Installing ASDM
2
3
4
5
3
Click [Install ASDM
Launcher].
Depending on your environ-
ment, the authentication dialog
box appears.
4
Click [OK].
Leave the username and pass-
word fields empty.
5
Click [Run].
The InstallShield Wizard for
Cisco ASDM Launcher appears.
Caution
If the Cisco ASDM web page does not appear, make sure that:
・
The POWER LED and STATUS LED are solid green.
・
You
connect a straight-through cable to an Ethernet port on the ASA.
・
Any pop-up blockers or proxy settings on your browser are disabled and that any
wireless client is disabled on your PC or laptop.
・
Your PC settings use DHCP. The ASA acts as a DHCP server. If your PC has a static IP ad-
dress, temporarily configure your PC settings to use DHCP.
Cisco ASA with FirePOWER Services Easy Setup Guide
2
Installing ASDM

Cisco ASA 5508-X Specifications

General

Maximum VPN Sessions	250
Power Supply	Internal
IPsec VPN Throughput	250 Mbps
USB 2.0	1
Memory	4 GB
Flash Memory	8 GB
AC Input	100-240 VAC
VPN Throughput	250 Mbps
Maximum VLANs	100
Operating Temperature	32 to 104°F (0 to 40°C)
Storage Temperature	-13 to 158°F (-25 to 70°C)
Ports	8 x 1GE
Security Contexts	2
New Connections per Second	20, 000
Management Interface	1 x GE
Frequency	50-60 Hz
New Sessions per Second	20, 000
Humidity	5% to 95% non-condensing