40
Step 4: Configure IPSec Encryption and Authentication parameters.
1. Choose the Encryption algorithm (DES/3DES/AES) and authentication algorithm (MD5/SHA).
2. Click Next to continue.
Step 5: Specify Local Hosts and Networks.
Identify hosts and networks at the local site to be allowed to use this IPSec tunnel to communicate with
the remote-site peers. (The remote-site peers will be specified in a later step.)
On page 5 of the VPN Wizard, add or remove hosts and networks dynamically by clicking on Add or
Delete respectively. In the current scenario, traffic from Network A (10.10.10.0) is encrypted by SA 1
and transmitted through the VPN tunnel.
To Next Page
Loading...
