Cisco ASA and Firepower Threat Defense
Reimage Guide
Cisco ASA and Firepower Threat Defense Reimage Guide
This guide describes how to reimage between ASA and Firepower Threat Defense (FTD), and also how to
perform a reimage for FTD using a new image version; this method is distinct from an upgrade, and sets the
FTD to a factory default state. For ASA reimaging, see the ASA general operations configuration guide, where
you can use multiple methods to reimage the ASA.
Supported Models
The following models support either ASA software or Firepower Threat Defense Software. For ASA and
Firepower Threat Defense version support, see the ASA compatibility guide or Firepower compatibility guide.
• ASA 5506-X
• ASA 5506W-X
• ASA 5506H-X
• ASA 5508-X
• ASA 5512-X
• ASA 5515-X
• ASA 5516-X
• ASA 5525-X
• ASA 5545-X
• ASA 5555-X
• ISA 3000
• Firepower 2100
The Firepower 4100 and 9300 also support either the ASA or Firepower Threat Defense, but they are installed
as logical devices; see the FXOS configuration guides for more information.
Note
Cisco ASA and Firepower Threat Defense Reimage Guide
1
To Next Page
Need help?
General
