EasyManuals Logo

Cisco ASA Series Configuration Guide

Cisco ASA Series
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #254 background imageLoading...
Page #254 background image
11-20
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 11 Service Policy Using the Modular Policy Framework
Examples for Service Policies (Modular Policy Framework)
Figure 11-3 HTTP Inspection and Connection Limits to Specific Servers
See the following commands for this example:
hostname(config)# object network obj-192.168.1.2
hostname(config-network-object)# host 192.168.1.2
hostname(config-network-object)# nat (inside,outside) static 209.165.201.1
hostname(config)# object network obj-192.168.1.0
hostname(config-network-object)# subnet 192.168.1.0 255.255.255.0
hostname(config-network-object)# nat (inside,outside) dynamic 209.165.201.2
hostname(config)# access-list serverA extended permit tcp any host 209.165.201.1 eq 80
hostname(config)# access-list ServerB extended permit tcp any host 209.165.200.227 eq 80
hostname(config)# class-map http_serverA
hostname(config-cmap)# match access-list serverA
hostname(config)# class-map http_serverB
hostname(config-cmap)# match access-list serverB
hostname(config)# policy-map policy_serverA
hostname(config-pmap)# class http_serverA
hostname(config-pmap-c)# inspect http
hostname(config-pmap-c)# set connection conn-max 100
hostname(config)# policy-map policy_serverB
hostname(config-pmap)# class http_serverB
hostname(config-pmap-c)# inspect http
hostname(config)# service-policy policy_serverB interface inside
hostname(config)# service-policy policy_serverA interface outside
Applying Inspection to HTTP Traffic with NAT
In this example, the Host on the inside network has two addresses: one is the real IP address 192.168.1.1,
and the other is a mapped IP address used on the outside network, 209.165.200.225. You must use the
real IP address in the ACL in the class map. If you applied it to the outside interface, you would also use
the real address.
inside outside
Server A
Real Address: 192.168.1.2
Mapped Address: 209.165.201.1
Host B
Real Address: 192.168.1.1
Mapped Address: 209.165.201.2:
port
Host A
209.165.200.226
Server B
209.165.200.227
port 80
port 80
insp.
insp.
set conns
143357
Security
appliance

Table of Contents

Other manuals for Cisco ASA Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASA Series and is the answer not in the manual?

Cisco ASA Series Specifications

General IconGeneral
ModelASA 5505
InterfacesVaries by model (Fast Ethernet, Gigabit Ethernet, 10 Gigabit Ethernet, etc.)
High AvailabilityActive/Standby or Active/Active (varies by model)
Power SupplyVaries by model
Form FactorVaries by model
Operating SystemCisco ASA Software
IPsec VPNSupported
SSL VPNSupported
IPS ThroughputVaries by model

Related product manuals