Cisco ASA Series

12-12
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 12 Getting Started with Application Layer Protocol Inspection
Configure Application Layer Protocol Inspection
icmp error See ICMP Error Inspection, page 13-21.
ils See ILS Inspection, page 15-12.
im [map_name]See Instant Messaging Inspection, page 13-21.
If you added an Instant Messaging inspection policy map
according to Configure an Instant Messaging Inspection
Policy Map, page 13-22, identify the map name in this
command.
ip-options [map_name]See IP Options Inspection, page 13-26.
If you added an IP Options inspection policy map according
to Configure an IP Options Inspection Policy Map,
page 13-28, identify the map name in this command.
ipsec-pass-thru [map_name]See IPsec Pass Through Inspection, page 13-30.
If you added an IPsec Pass Through inspection policy map
according to Configure an IPsec Pass Through Inspection
Policy Map, page 13-31, identify the map name in this
command.
ipv6 [map_name]See IPv6 Inspection, page 13-33.
If you added an IPv6 inspection policy map according to
Configure an IPv6 Inspection Policy Map, page 13-34,
identify the map name in this command.
mgcp [map_name]See MGCP Inspection, page 14-12.
If you added an MGCP inspection policy map according to
Configuring an MGCP Inspection Policy Map for
Additional Inspection Control, page 14-14, identify the map
name in this command.
netbios [map_name]See NetBIOS Inspection, page 13-37.
If you added a NetBIOS inspection policy map according to
Configure a NetBIOS Inspection Policy Map for Additional
Inspection Control, page 13-37, identify the map name in
this command.
pptp See PPTP Inspection, page 13-39.
radius-accounting map_name See RADIUS Accounting Inspection, page 15-13.
The radius-accounting keyword is only available for a
management class map. You must specify a RADIUS
accounting inspection policy map; see Configure a RADIUS
Accounting Inspection Policy Map, page 15-14.
rsh See RSH Inspection, page 15-16.
rtsp [map_name]See RTSP Inspection, page 14-17.
If you added a RTSP inspection policy map according to
Configure RTSP Inspection Policy Map, page 14-19,
identify the map name in this command.
Table 12-2 Protocol Keywords
Keywords Notes