CHAPTER 10
Installing the IP54 Kit
This chapter contains the following sections:
• Overview of the IP54 Kit, on page 69
• Installing the IP54 Kit, on page 71
Overview of the IP54 Kit
The IR1800 has a kit, which when installed, provides dust and water protection and discourages tampering.
The PID is IR1800-IP54-KIT.
Before you begin, make sure that you have completed all of the standard installation steps described in the
earlier chapters of this guide.
The IP54 kit installed with the router is not intended tomeet the Hazardous Locations IP54 requirement according
to IEC 60079-7:2018, clause 23.
Caution
All the cabling that extends from the router and gets terminated elsewhere, that is, Power, Ethernet, Antenna,
and so on, must have a minimum ingress protection rating of IP54 according to EN60529 when used in
conjunction with the IP54 kit. It is the responsibility of the customer to ensure that all cabling and terminations
outside of the router meet the required ingress protection requirement. In addition, the router is
not
designed
for and should not be placed outdoors. The intent of the IP54 kit is to provide supplementary protection to the
router against dust and occasional splashing water. Cisco cannot guarantee prolonged reliable operation of
the router if these guidelines are violated.
Caution
Before beginning the installation of the IP54 kit, considercarefully whether the installation site is strong enough
to support the combined weight of the IP54 enclosure and the router that it encloses.
Caution
The IP54 kit contains:
• Front Cover Components
• Back Cover
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
69
To Next Page
Loading...
Need help?
General
