Step 6 Attach the top cover plate to the top cover using four more of the provided screws.
Step 7 The following figure shows the final assembly.
Installing the Back Cover
The back cover is installed as a single piece using eight screws provided.
Procedure
Step 1 Make sure that all the slots have pluggable modules or blanks, and that all the antennae are removed before
attaching the back cover.
If your pluggable module has a USB port cover attached, remove the cover. If the USB port cover
is installed along with the IP54 back cover, it will interfere with the installation.
Note
Step 2 Attach the back cover to the back of the chassis over the pluggable modules using eight of the provided screws.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
73
Installing the IP54 Kit
Installing the Back Cover
To Next Page
Loading...
Need help?
General
