Setting Video Parameters
How to Set Video Parameters for Cisco Unified SRST
261
Cisco Unified SCCP and SIP SRST System Administrator Guide
OL-13143-04
To display information about RTP named-event packets, such as caller-ID number, IP address, and port
for both the local and remote endpoints, use the show voip rtp connection command as shown in the
following sample output:
Router# show voip rtp connections
VoIP RTP active connections :
No. CallId dstCallId LocalRTP RmtRTP LocalIP RemoteIP
1 102 103 18714 18158 10.1.1.1 192.168.1.1
2 105 104 17252 19088 10.1.1.1 192.168.1.1
Found 2 active RTP connections
============================
How to Set Video Parameters for Cisco Unified SRST
When the Cisco Unified SRST is enabled, Cisco Unified IP phones do not have to be reconfigured for
video capabilities because all ephones retain the same configuration used with Cisco Unified CM.
However, you can set video parameters for Cisco Unified SRST.
Setting Video parameters for Cisco Unified SRST involves the following tasks:
• Configuring Slow Connect Procedures, page 261
• Verifying Cisco Unified SRST, page 262
• Setting Video Parameters for Cisco Unified SRST, page 268
Configuring Slow Connect Procedures
Video streams require slow-connect procedures for Cisco Unified SRST. H.323 endpoints require a slow
connect because the endpoint-capability match occurs after the connect message.
Note For more information about slow-connect procedures, see Configuring Quality of Service for Voice.
Use the following procedure to configure slow-connect procedures.
SUMMARY STEPS
1. enable
2. configure terminal
3. voice service voip
4. h323
5. call start slow
To Next Page
Loading...