Cisco CRS-1 - Carrier Routing System Router - CHAPTER 5 Provisioning Additional Subsystems

Implementing Internet Key Exchange Security Protocol on Cisco IOS XR Software
How to Implement IKE Security Protocol Configurations for IPSec Networks
SC-131
Cisco IOS XR System Security Configuration Guide for the Cisco CRS-1 Router
OL-20382-01
Configuring the System Resource Limit
This task configures the system resource limit.
SUMMARY STEPS
1. configure
2. crypto isakmp call admission limit {cpu {total percent | ike percent}}
3. end
or
commit
4. show cyrpto isakmp call admission statistics
Step 3
end
or
commit
Example:
RP/0/RP0/CPU0:router(config)# end
or
RP/0/RP0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to
the running configuration file, exits the
configuration session, and returns the
router to EXEC mode.
– Entering no exits the configuration session
and returns the router to EXEC mode
without committing the configuration
changes.
– Entering cancel leaves the router in the
current configuration session without
exiting or committing the configuration
changes.
• Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
Step 4
show cyrpto isakmp call admission statistics
Example:
RP/0/RP0/CPU0:router# show crypto isakmp call
admission statistics
Monitors crypto CAC statistics.
Command or Action Purpose