Cisco CRS-1 - Carrier Routing System Router Configuration Guide

Configuring AAA Services on Cisco IOS XR Software
How to Configure AAA Services
SC-37
Cisco IOS XR System Security Configuration Guide for the Cisco CRS-1 Router
OL-20382-01
Step 4
Repeat Step 3 for every external server to be added to
the server group named in Step 2.
—
Step 5
server-private {hostname | ip-address}
[auth-port port-number] [acct-port port-number]
[timeout seconds] [retransmit retries] [key
string]
Example:
RP/0/RP0/CPU0:router(config-sg-radius)# server-
private 10.10.130.2 auth-port 1600 acct-port
1666 key code
Configures the IP address of the private RADIUS server for
the group server.
Note If private server parameters are not specified, global
configurations are used. If global configurations are
not specified, default values are used.
Step 6
deadtime minutes
Example:
RP/0/RP0/CPU0:router(config-sg-radius)#
deadtime 1
Configures the deadtime value at the RADIUS server group
level.
• The minutes argument specifies the length of time, in
minutes, for which a RADIUS server is skipped over by
transaction requests, up to a maximum of 1440 (24
hours). The range is from 1 to 1440.
The example specifies a one-minute deadtime for RADIUS
server group radgroup1 when it has failed to respond to
authentication requests for the deadtime command
Note You can configure the group-level deadtime after
the group is created.
Step 7
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-sg-radius)# end
or
RP/0/RP0/CPU0:router(config-sg-radius)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
– Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
– Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Step 8
show radius server-groups [group-name [detail]]
Example:
RP/0/RP0/CPU0:router# show radius server-groups
(Optional) Displays information about each RADIUS
server group that is configured in the system.
Command or Action Purpose

Cisco CRS-1 - Carrier Routing System Router Specifications

General

Brand	Cisco
Model	CRS-1 - Carrier Routing System Router
Category	Network Router
Language	English