Cisco EPC2425 EuroDOCSIS 2.0 - RF Specifications

Data Sheet
© 2010 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 5 of 8
Specification
Value
Voice Specifications
Audio Gain Levels
Independently Configurable Tx and Rx audio gains
Silence Suppression
Configurable VAD with comfort noise generation
Packet Loss Concealment
ANSI T1.521-1999
Call Connection Quality
Monitoring
RTCP, RFC1889, RFC1890, SNMP MIB for last call quality statistics
Dialing Modes
DTMF and configurable pulse dial support
DTMF Relay
RFC2833 including fast (40mS) DTMF Relay for alarm system signaling compatibility
Layer 2 Quality of Service
●
Full PacketCable secure DQOS with GateID including UGS and UGS/AD
●
DQOS Lite support including UGS and UGS/AD
Layer 3 Quality of Service
Configurable DiffServe/TOS support for Signaling, RTP, and RTCP flows
Payload Header
Suppression (PHS)
Supported for RTP and RTCP packet flows to reduce per-call network bandwidth.
Advanced support for Dynamic Payload Header Suppression using Propane Technology.
Management
SNMPv3, SNMPv2, Telnet with configurable user ID and password, internal log, and external
Syslog support
Echo Cancellation
G.168 with extended echo tail support
Call Feature Support
●
Caller ID
●
Call Waiting with Caller ID
●
Cancel Call Waiting
●
Call Conferencing (3-way calls)
●
Configurable hook flash support
●
Distinctive Ringing (Configurable for up to 11 ring patterns per phone line)
●
Ring Splash
●
Stutter Dial Tone
●
Off hook warning tone
●
Open Switch Interval support to enhance answering machine compatibility
●
Configurable star codes
●
Euro/US hook-flash type
●
Call transfer
●
Message Waiting Indicator
●
Warm Line
●
Call Forwarding Unconditional
●
Call Forwarding on Busy
●
Call Forwarding No Answer
●
Call return
●
Redial Call
●
Automatic redial
●
Other call features available with compliant CMS or gateway
Telephone Ring Loading
Full 5 REN support on each phone line (10 REN total)
Ring Signal
Configurable balanced ring with configurable DC offset
Max Phone Line Distance
Supports up to 1000 ft of AWG26 wire (0.4mm) on each phone line. Supports operation with
typical in-home telephone wiring
Country-Specific
Telephone Parameters
Supported
United States,United Kingdom, Germany, France, Belgium, Netherlands, Finland, Italy,
Switzerland, Sweden, Denmark, Brazil, ETSI 101 909-18
RF Downstream
Frequency Range
108 to 930 MHz
Demodulation
64 or 256 QAM
Maximum Data Rate
41.4 Mbps for 64 QAM
55.2 Mbps for 256 QAM
Bandwidth
8 MHz
Operating Level Range
43 to 73 dBµV for 64 QAM
47 to 77 dBµV for 256 QAM
Input Impedance
75 ohms