13
Connecting to an HDTV with a DVI Connector
Notes:
• When you connect the HDMI connector to the DVI connector on your HDTV, you need an HDMI-to-DVI adaptor
and a separate audio connection.
• Digital content is encrypted with High-Bandwidth Content Protection (HDCP) on the DVI/HDMI port. This set-to is
not compatible with devices that do not support HDCP. You must use either the YPbPr or 1394 connection (which
uses Digital Transmission Content Protection, or DTCP) to connect the set-top to these devices.
• Also refer to the Important Notes Regarding the HDMI Interface on the Set-Top on page 12.
WARNING: Electric shock hazard! Unplug all electronic devices before connecting or
disconnecting any device cables to the set-top.
Required cables:
• 1 HDMI-to-DVI or 1 HDMI cable and 1 DVI adapter
• 1 audio Left/Right cable
Back of Set-Top
CATV CONVERTER
MADE IN MEXICO
LISTED 36MW
VIDEO PRODUCT
AVI S:
RISQUE DE CHOC
ÉLECTRIQUE NE PAS OUVRIR
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
S-VIDEO
OUT
OPTICAL
AUDIO
OUT
IR
DIGITAL
AUDIO
OUTPUT
RPrR
LPb L
YVIDEO
CABLE IN
120V~
60Hz 40W
120 VAC
60Hz 4.2A
500W
CABLE OUT
USB 2.0HDMI eSATA ETHERNET1394
THIS DEVICE IS INTENDED TO BE ATTACHED
TO A RECEIVER THAT IS NOT USED TO
RECEIVE OVER-THE-AIR BROADCAST
SIGNALS. CONNECTION OF THIS DEVICE
IN ANY OTHER FASHION MAY CAUSE
HARMFUL INTERFERENCE TO RADIO
COMMUNICATIONS AND IS IN VIOLATION
OF THE FCC RULES, PART 15.
STB RF MAC: 001CEA0B782C
STB SN: SABQTMNWW
HDMI
AUDIO
CENTER
CHANNEL IN
AUDIO IN
DVI/HDCP
ANT (75 )
INOUT
LR
ANT-1
HD 2
Y
OUT
ANT-2
PB
PR
L
R
VIDEO
L/
MONO
R
L/
MONO
R
AUDIO
IN
ON OFF
IN
HD 1
S-VIDEO
VIDEO
Y
PB
PR
L
R
AUDIOAUDIO
DVI/HDCP
IN
AUDIO IN
DVI/HDCP
LR
Cable
Input
T16222
Back of
HDTV
To Next Page
Loading...
