Cisco Flip UltraHD - Connect to Computer; Recharge Battery Pack

Connect to Computer
1 Slide USB latch down. USB arm flips up automatically.
2 Plug USB arm into USB port on computer.
3 The battery pack will begin recharging and you can install
pre-loaded FlipShare™ software on your computer.
Recharge Battery Pack
1 Slide USB latch down. USB arm flips up automatically.
2 Plug USB arm into USB port on computer.
3 Screen will display charging status.
displays to indicate charging in process.
displays to indicate a fully-charged battery.
• Fully recharging the battery pack takes up to 3 hours.
• Disconnect your video camera from the computer after charging
to help preserve the battery pack’s lifespan and performance.
Note: Your computer must be powered on for your video camera to charge.
1
2