Statement 1074—Comply with Local and National Electrical Codes
To reduce risk of electric shock or fire, installation of the equipment must comply with local and national
electrical codes.
Warning
Step 1 Remove the power supply:
a) Grasp the power supply handle while pinching the release lever toward the handle.
b) Pull the power supply out of the bay.
Figure 35: Remove and Replace the AC Power Supply 429121
Handle2Release lever1
Step 2 Install a new power supply:
a) Grasp the power supply handle and insert the new power supply into the empty bay.
b) Push the power supply into the bay until the release lever locks.
c) Connect the power cord to the new power supply.
d) If you shut down the FMC, press the Power button to return it to main power mode.
Cisco Firepower Management Center 1600, 2600, and 4600 Hardware Installation Guide
40
Installation, Maintenance, and Upgrade
Remove and Replace a Power Supply
To Previous Page
Loading...
