4
Installation (English)
NOTE: The Network Storage System supports up to two 3.5-inch,
Serial-ATA (SATA) hard drives, so use hard drives equipped with the
SATA interface. Before you begin, back up any pre-existing data
because all data on your hard drives will be erased.
WARNING: Low-prole or half-height hard drives can be used at your
own risk; however, Linksys does not support the use of these drives
as they are not securely held in place inside the Network Storage
System.
Make sure the Network Storage
System is powered off.
Insert the Setup Wizard CD-ROM
into your computer’s CD-ROM
drive. The Setup Wizard should run
automatically, and the Welcome
screen should appear. If it does not,
click Start and then Run. In the
field provided, enter
D:\SetupUtility.exe (if “D” is the
letter of your CD-ROM drive).
If a language selection screen
appears, select your preferred
language. Then click Next/Install.
Click the Click Here to Start
button.
A.
B.
C.
D.
Insert the CD-ROMInsert the CD-ROM
Click Here to StartClick Here to Start
To Next Page
Loading...
Need help?
General
