Cisco ONS 15454 SDH - Perform a Facility (Line) Loopback on a Source Electrical Port (West to East)

15-10
Cisco ONS 15454 SDH Reference Manual, R4.6
April 2008
Chapter 15 Performance Monitoring
15.4.3 DS3i-N-12 Card Performance Monitoring Parameters
15.4.3 DS3i-N-12 Card Performance Monitoring Parameters
Figure 15-5 shows the signal types that support near-end and far-end PM parameters for the DS3i-N-12
card. Figure 15-6 shows where overhead bytes detected on the ASICs produce performance monitoring
parameters for the DS3i-N-12 card.
Figure 15-5 Monitored Signal Types for the DS3i-N-12 Card
Figure 15-6 PM Read Points on the DS3i-N-12 Card
71108
ONS 15454
SDH
DS3i STM16
Fiber
Near End
DS3 Signal
C-Bit and M23 Framing DS3 Path Near-End PMs Are Supported
ONS 15454
SDH
DS3iSTM16
Far End
DS3 Signal
VC3 Low-Order Path PMs Supported for Near and Far-End
VC4 High-Order Path PMs Supported for Near and Far-End
71103
ONS 15454 SDH
DS3i Card
LIU
Mux/Demux ASIC
BTC
ASIC
Cross-Connect
Card STM-N
DS3 Side SDH Side
CV-L
ES-L
SES-L
LOSS-L
AISS-P
CVP-P
ESP-P
SASP-P
SESP-P
UASP-P
CVCP-P
ESCP-P
SASCP-P
SESCP-P
UASCP-P
CVCP-PFE
ESCP-PFE
SASCP-PFE
SESCP-PFE
UASCP-PFE
PMs read on Mux/Demux ASIC
PMs read on LIU
Low-
Order
Path
Level
SDH Side
LP-EB
LP-BBE
LP-ES
LP-SES
LP-UAS
LP-ESR
LP-SESR
LP-BBER
HP-EB
HP-BBE
HP-ES
HP-SES
HP-UAS
HP-ESR
HP-SESR
HP-BBER
High-
Order
Path
Level