To Next PageTo Next Page
Need help?Do you have a question about the Cisco ONS 15454 and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Management | Cisco Transport Controller (CTC), TL1, SNMP |
| Protocols | SONET/SDH, Ethernet, OTN |
| Power Supply | Redundant AC or DC power supplies |
| Slots | 17 |
| Supported Interfaces | OC-3/STM-1 to OC-192/STM-64, 10/100/1000 Ethernet, 10G Ethernet |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Humidity | 5% to 95% non-condensing |
| Weight | Approximately 75 lb (34 kg) |
| Interfaces/Ports | Ethernet, SONET/SDH, Fibre Channel |
Details changes made to the publication across different releases, including updates to alarm details and specific sections.
Explains the guide's purpose, intended audience, publication organization, and conventions used.
Describes the expected familiarity with Cisco or equivalent optical transmission hardware, telecommunications, and electronic circuitry.
Lists other Cisco publications that should be used in conjunction with this guide for comprehensive information.
Outlines the publication's conventions for formatting, keywords, command input, and examples.
Provides information specific to optical networking products.
Directs users to the Cisco Optical Transport Products Safety and Compliance Information document for safety details.
Informs users about the availability of documentation on a CD-ROM package.
Provides information on obtaining documentation, submitting service requests, and gathering additional information.
Describes loopbacks and hairpin circuits used to test circuit paths and isolate faults.
Explains how to use loopback tests to isolate trouble on DS-1, DS-3, or EC-1 electrical circuits.
Describes DS3XM-6 and DS3XM-12 card far-end alarm and control (FEAC) functions.
Explains using loopback tests to isolate trouble on OC-N optical circuits.
Explains using loopback tests to isolate trouble on G-Series or CE-Series Ethernet circuits.
Explains using loopbacks to isolate trouble on Fibre Channel (FC_MR) circuits.
Provides procedures for verifying card LED operation, creating diagnostic circuits, and retrieving diagnostic files.
Contains troubleshooting for node operation errors requiring restoration of software data or default node setup.
Provides information on system minimum requirements and troubleshooting procedures for PC and network connectivity.
Groups alarms and conditions by their default severities (Critical, Major, Minor, NA, NR) as reported in CTC or TL1.
Provides an alphabetical list of all ONS 15454 alarms and conditions.
Defines the logical objects against which alarms and conditions are raised, representing physical or logical entities.
Lists ONS 15454 alarms and logical objects as organized in the system alarm profile.
Covers safety considerations for safe operation of the ONS 15454, including precautions for card installation/removal.
Describes how the ONS 15454 system reports trouble using standard alarm and condition characteristics.
Lists alarms alphabetically and includes common conditions encountered when troubleshooting alarms.
Lists all ONS 15454 transient conditions alphabetically with their entity, SNMP number, and SNMP trap.
Describes how the ONS 15454 system reports trouble using standard condition characteristics and GUI state indicators.
Lists transient conditions encountered in Software Release 7.2, including descriptions, entities, and SNMP information.
Lists Cisco ONS 15454, 15454 SDH, and other ONS series error messages, including error title, ID, and message.
