3-3
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 3 Transient Conditions
3.2 Trouble Notifications
3.2 Trouble Notifications
The ONS 15454 system reports trouble by using standard condition characteristics that follow the rules
in Telcordia GR-253 and graphical user interface (GUI) state indicators.
The ONS 15454 uses standard Telcordia categories to characterize levels of trouble. The system reports
trouble notifications as alarms and reports status or descriptive notifications (if configured to do so) as
conditions in the CTC Alarms window. Alarms typically signify a problem that you need to remedy, such
as a loss of signal. Conditions do not necessarily require troubleshooting.
3.2.1 Condition Characteristics
Conditions include any problem detected on an ONS 15454 shelf. They can include standing or transient
notifications. You can retrieve a snapshot of all currently raised conditions on the network, node, or card
in the CTC Conditions window or by using the RTRV-COND commands in TL1.
Note Some cleared conditions are found on the History tab.
3.3.29 PM-TCA, page 3-8 — 2120 performanceMonitorThre
sholdCrossingAlert
3.3.30 PS, page 3-9 EQPT 2130 protectionSwitch
3.3.31 RMON-ALARM, page 3-9 — 2720 rmonThresholdCrossingA
larm
3.3.32 RMON-RESET, page 3-9 — 2710 rmonHistoriesAndAlarms
ResetReboot
3.3.33 SFTWDOWN-FAIL, page 3-9 EQPT 3480 softwareDownloadFailed
3.3.34 USER-LOCKOUT, page 3-9 NE 5030 userLockedOut
3.3.35 USER-LOGIN, page 3-9 NE 5100 loginOfUser
3.3.36 USER-LOGOUT, page 3-9 NE 5120 logoutOfUser
3.3.37 WORK-QUEUE-FULL, page 3-10 EQPT
3.3.38 WKSWBK, page 3-10 EQPT,
OCN
2640 switchedBackToWorking
3.3.39 WKSWPR, page 3-10 2R,
TRUNK,
EQPT,
ESCON,
FC, GE,
ISC, OCN,
STSMON,
VT-MON
2650 switchedToProtection
3.3.40 WTR-SPAN, page 3-10 — 3420 spanIsInWaitToRestoreSt
ate
Table 3-1 ONS 15454 Transient Condition Alphabetical Index (continued)
Transient Condition Entity SNMP Number SNMP Trap
To Next Page
Loading...
