Cisco ONS 15454 - 2.7.280 MS-DEG; 2.7.281 MS-EXC; 2.7.282 MT-OCHNC; 2.7.283 NO-CONFIG

2-187
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 2 Alarm Troubleshooting
2.7.280 MS-DEG
Step 2 If the reset card has not rebooted successfully, or the alarm has not cleared, call Cisco TAC
1 800 553-2447. If the Cisco TAC technician tells you to reseat the card, complete the “Remove and
Reinsert (Reseat) the Standby TCC2/TCC2P Card” procedure on page 2-272. If the Cisco TAC
technician tells you to remove the card and reinstall a new one, complete the “Physically Replace a
Traffic Card” procedure on page 2-273.
Step 3 If the MFGMEM alarm continues to report after replacing the TCC2/TCC2Ps, the problem lies with the
EEPROM.
Step 4 If the MFGMEM is reported from the fan-tray assembly, obtain a fan-tray assembly and complete the
“Replace the Fan-Tray Assembly” procedure on page 2-280.
Step 5 If the MFGMEM is reported from the AIP, the backplane, or the alarm persists after the fan-tray
assembly is replaced, log into the Technical Support Website at http://www.cisco.com/techsupport for
more information or call Cisco TAC 1 800 553-2447 to report a Service-Affecting (SA) problem.
2.7.280 MS-DEG
The MS-DEG condition is not used in this platform in this release. It is reserved for development.
2.7.281 MS-EXC
The MS-EXC condition is not used in this platform in this release. It is reserved for development.
2.7.282 MT-OCHNC
For information about this alarm or condition, refer to the “Alarm Troubleshooting” chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide. This guide discusses all DWDM alarms.
2.7.283 NO-CONFIG
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
The No Startup Configuration condition applies to ML-Series Ethernet cards and occurs when no startup
configuration file has been downloaded to the TCC2/TCC2P, whether or not you preprovision the card
slot. This alarm can be expected during provisioning. When the startup configuration file is copied to the
active TCC2/TCC2P, the alarm clears.
Note For more information about the ML-Series Ethernet cards, refer to the Cisco ONS 15454 and
Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide.
Clear the NO-CONFIG Condition
Step 1 Create a startup configuration for the card in Cisco IOS.