Cisco ONS 15454 - 1.11 Circuits and Timing

1-134
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 1 General Troubleshooting
1.11 Circuits and Timing
Figure 1-51 Configuring VLAN Membership for Individual Ethernet Ports
Step 3
If the port is set to Tagged, continue to look at other cards and their ports in the VLAN until you find
the port that is set to Untag.
Step 4 At the VLAN port set to Untag, click the port and choose Tagged.
Note The attached external devices must recognize IEEE 802.1Q VLANs.
Step 5 After each port is in the appropriate VLAN, click Apply.
1.11 Circuits and Timing
This section provides solutions to circuit creation and reporting errors, as well as common timing
reference errors and alarms.