Cisco ONS 15454 - 1.8 Restoring the Database and Default Settings

1-114
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 1 General Troubleshooting
1.8 Restoring the Database and Default Settings
Figure 1-47 DCN Tools OSPF Dump
The dump, which provides the same information as a dump executed by special networking commands,
is available at the network view in the Maintenance > Diagnostic tabs. You can select the access point
node in the Select Node drop-down list. To create the dump, click Retrieve. (To clear the dump, click
Clear.)
The contents of the dump file can be saved or printed and furnished to Cisco Technical Support for use
in OSPF network support.
1.8 Restoring the Database and Default Settings
This section contains troubleshooting for node operation errors that require restoring software data or
the default node setup.
1.8.1 Restore the Node Database
Symptom One or more nodes does not function properly or has incorrect data.
Possible Cause Incorrect or corrupted node database.
Recommended Action Complete the procedures in the “Maintain the Node” chapter of the
Cisco ONS 15454 Procedure Guide.