3-7
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 3 Transient Conditions
3.3.17 EFM-SYM-PER
3.3.17 EFM-SYM-PER
The EFM Link Monitoring - Errored Symbol Period Event condition occurs when the symbol errors
detected at the remote NE cross a configured threshold. This condition notifies the user onthe local NE
of this threshold crossing.
This transient condition does not result in a standing condition.
3.3.18 FIREWALL-DIS
The Firewall Has Been Disabled (FIREWALL-DIS) condition occurs when you provision the firewall to
Disabled.
This transient condition does not result in a standing condition.
3.3.19 FRCDWKSWBK-NO-TRFSW
The Forced Switch Back to Working Resulted in No Traffic Switch (FRCDWKSWBK-NO-TRFSW)
condition occurs when you perform a Force Switch to the working port/card and the working port/card
is already active.
This transient condition might result in a Force Switch (Ring or Span) standing condition for a BLSR.
3.3.20 FRCDWKSWPR-NO-TRFSW
The Forced Switch to Protection Resulted in No Traffic Switch (FRCDWKSWPR-NO-TRFSW)
condition occurs when you perform a Force Switch to the protect port/card, and the protect port/card is
already active.
This transient condition does not result in a standing condition.
3.3.21 INTRUSION
The Invalid Login Username (INTRUSION) condition occurs when you attempt to login with an invalid
user ID.
This transient condition does not result in a standing condition.
3.3.22 IOSCFG-COPY-FAIL
The IOS Config Copy Failed (IOSCFG-COPY-FAIL) condition occurs on ML-Series Ethernet cards
when the software fails to upload or download the Cisco IOS startup configuration file to or from an
ML-Series card. This condition is similar to the “SFTWDOWN-FAIL” condition on page 3-9, but the
IOSCFG-COPY-FAIL condition applies to ML-Series Ethernet cards rather than the TCC2/TCC2P card.
To Next Page
Loading...
