CHAPTER
2-1
Cisco ONS 15454 Procedure Guide, R8.0
78-17697-01
2
Install Cards and Fiber-Optic Cable
This chapter explains how to install the Cisco ONS 15454 cards and fiber-optic cable.
Before You Begin
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-A15 Install the Common Control Cards, page 2-2—Complete this procedure first before
installing any other cards.
2. NTP-A16 Install Optical Cards and Connectors, page 2-7—Complete as needed.
3. NTP-A17 Install the Electrical Cards, page 2-10—Complete as needed.
4. NTP-A246 Install Ethernet Cards and Connectors, page 2-11—Complete as needed.
5. NTP-A274 Install the FC_MR-4 Card, page 2-13—Complete as needed.
6. NTP-A316 Install the Filler Cards, page 2-15—Complete as needed.
7. NTP-A247 Install Fiber-Optic Cables, page 2-16—Complete this procedure to install fiber-optic
cable on optical cards.
8. NTP-A245 Route Fiber-Optic Cables, page 2-19—Complete as needed.
9. NTP-A116 Remove and Replace a Card, page 2-20—Complete this procedure as needed to remove
and replace a card, including deleting the card from Cisco Transport Controller (CTC) and changing
an OC-N card without losing the card’s provisioning.
10. NTP-A20 Replace the Front Door, page 2-21—If the front door was removed, complete this
procedure to replace the front door and ground strap after installing cards and fiber-optic cable.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning
Filler cards serve three important functions: they prevent exposure to hazardous voltages and
currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system
unless all cards and faceplates are in place.
Statement 156
To Next Page
Need help?
General
