2-20
Cisco ONS 15454 Procedure Guide, R8.0
78-17697-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- A116 Remove and Replace a Card
Step 6 Route the fiber-optic cables out either side of the cable-management tray through the cutouts on each
side of the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Step 7 Close the fold-down front door when all fiber-optic cables in the front compartment are properly routed.
Stop. You have completed this procedure.
NTP-A116 Remove and Replace a Card
Step 1 If you are not logged into CTC and you need to remove a card, remove the card as described in Step 3.
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) with the
Cisco ONS 15454 Troubleshooting Guide.
Step 2 If you are logged into CTC, complete one of the following:
• Complete the “DLP-A191 Delete a Card” task on page 18-63 and continue with Step 3.
• Complete the “DLP-A247 Change an OC-N Card” task on page 19-29 to delete a card and replace
it with a different OC-N card while maintaining existing provisioning.
Step 3 Physically remove the card:
a. Open the card latches/ejectors.
b. Use the latches/ejectors to pull the card forward and away from the shelf.
Step 4 Insert the new card using one of the following procedures as applicable:
• NTP-A15 Install the Common Control Cards, page 2-2
• NTP-A16 Install Optical Cards and Connectors, page 2-7
• NTP-A17 Install the Electrical Cards, page 2-10
• NTP-A246 Install Ethernet Cards and Connectors, page 2-11
• NTP-A274 Install the FC_MR-4 Card, page 2-13
Step 5 As needed, continue with the “NTP-A247 Install Fiber-Optic Cables” procedure on page 2-16.
Stop. You have completed this procedure.
Purpose This procedure removes and replaces all cards housed in the ONS 15454
shelf and rack.
Tools/Equipment None
Prerequisite Procedures A card installation procedure
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
