2-2
Cisco ONS 15454 Procedure Guide, R8.0
78-17697-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- A15 Install the Common Control Cards
NTP-A15 Install the Common Control Cards
Warning
During this procedure, wear grounding wrist straps to avoid electrostatic discharge (ESD) damage to
the card. Do not directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
Statement 94
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside edge of the shelf assembly.
Caution If protective clips are installed on the backplane connectors of the cards, remove the clips before
installing the cards.
Note If you install a card incorrectly, the FAIL LED flashes continuously.
Step 1 If you plan to install XCVT cards, review Table 2-1 to determine card/slot compatibility. If you plan to
install XC10G or XC-VXC-10G cards, review Table 2-2 on page 2-5 to determine card/slot
compatibility.
Step 2 Complete the “DLP-A36 Install the TCC2/TCC2P Cards” task on page 17-38.
Step 3 Complete the “DLP-A37 Install the XCVT, XC10G, or XC-VXC-10G Cards” task on page 17-41.
Step 4 Complete the “DLP-A41 Install the Alarm Interface Controller–International Card” task on page 17-43,
as needed.
Note If you install the wrong card in a slot, see the “NTP-A116 Remove and Replace a Card”
procedure on page 2-20.
Step 5 Install the traffic cards. To determine the appropriate procedure for a particular card, see the NTP list in
the “Before You Begin” section on page 2-1.
In Table 2-1, X indicates that a card is supported in the slot. The multiservice (traffic) slots, Slots 1 to 6
and 12 to 17, include four slots (Slots 5, 6, 12, and 13) that have four times the bandwidth of the other
multiservice slots.
Purpose This procedure describes how to install the common control cards.
Tools/Equipment Redundant TCC2/TCC2P cards
Redundant XCVT, XC10G, or XC-VXC-10G (cross-connect) cards
AIC-I card (optional)
Prerequisite Procedures NTP-A13 Perform the Shelf Installation Acceptance Test, page 1-30
Required/As Needed Required
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
