2-5
Cisco ONS 15454 Procedure Guide, R8.0
78-17697-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- A15 Install the Common Control Cards
In Table 2-2, X indicates that a card is supported in the slot. The multiservice (traffic) slots, Slots 1 to 6
and 12 to 17, include four slots (Slots 5, 6, 12, and 13) that have four times the bandwidth of the other
multiservice slots. The XC10G and XC-VXC-10G cards require the ANSI shelf (5454-SA-ANSI) or the
high-density shelf (15454-SA-HD).
Note For specific slot restrictions for a particular card, consult the card reference section for that card in the
Cisco ONS 15454 Reference Manual.
1. This identifies 1:N cards that operate as normal DS1 or DS3 cards when installed in certain slots.
2. This DS3 card cannot be used in this slot if used with a high-density electrical interface assembly (EIA) or in a 1:N configuration.
3. This card can only be used with the XCVT card, not the XC card.
4. The OC48AS will operate in Slots 5, 6, 12, and 13 with the XC/XCVT in R3.4 through R4.6, and the OC48AS will operate in Slots 5, 6, 12, and 13 with
the XCVT in R5.0 and later. In Release R3.3 and earlier, OC48AS with XC/XCVT is not supported.
Table 2-2 Card and Slot Compatibility for the XC10G and XC-VXC-10G Cards
Slot 123456789 1011121314151617
Type MS MS MS MS MS MS TCC XC AIC-I XC TCC MS MS MS MS MS MS
TCC2/TCC2P X X
XC10G X X
XC-VXC-10G X X
AIC-I X
DS1-14 XXXXXX XXXXXX
DS1N-14 X
1
X
1
XX
1
X
1
X
1
X
1
X
1
X
1
XX
1
X
1
DS1/E1-56 XXX XXX
DS3-12 XXXXXX XXXXXX
DS3-12E XXXXXX XXXXXX
DS3N-12 X
1
X
1
XX
1
X
1
X
1
X
1
X
1
X
1
XX
1
X
1
DS3N-12E X
1
X
1
XX
1
X
1
X
1
X
1
X
1
X
1
XX
1
X
1
DS3XM-6 XXXXXX XXXXXX
DS3XM-12 XXXXXX XXXXXX
DS3/EC1-48 XXX XXX
EC1-12 XXXXXX XXXXXX
E100T-12 Not supported with the XC10G or XC-VXC-10G cards.
E1000-2 Not supported with the XC10G or XC-VXC-10G cards.
E100T-G XXXXXX XXXXXX
E1000-2-G XXXXXX XXXXXX
CE-100T-8 XXXXXX XXXXXX
CE-1000-4 XXXXXX XXXXXX
G1K-4 XXXXXX XXXXXX
ML100-12 XXXXXX XXXXXX
To Next Page
Loading...
