2-20
Cisco ONS 15454 Troubleshooting Guide, R8.5
November 2009
Chapter 2 Alarm Troubleshooting
2.3 Alarm Logical Objects
Alarm profile list objects are defined in Table 2-7.
Note Alarm logical object names can appear as abbreviated versions of standard terms used in the system and
the documentation. For example, the “OCN” logical object refers to the OC-N signal. Logical object
names or industry-standard terms are used within the entries as appropriate.
Table 2-7 Alarm Logical Object Type Definitions
Logical Object Definition
2R Reshape and retransmit (used for transponder [TXP] cards).
AICI-AEP Alarm Interface Controller–International/alarm expansion panel. A combination
term that refers to this platform’s AIC-I card.
AICI-AIE Alarm Interface Controller-International/Alarm Interface Extension. A
combination term that refers to this platform's AIC-I card.
AIP Alarm Interface Panel.
AOTS Amplified optical transport section. For information about AOTS alarms, refer to
the “Alarm Troubleshooting” chapter in the Cisco ONS 15454 DWDM
Troubleshooting Guide.
BIC Backplane interface connector.
BITS Building integrated timing supply incoming references (BITS-1, BITS-2).
BPLANE The backplane.
CE1000 CE-1000-4 card.
CE100T CE-100T-8 card.
CEMR CE-MR-10 card.
CTRL Control channel.
DS1 A DS-1 line on a DS-1 or DS-3 electrical card (DS1-14, DS3N-12E, DS3XM-6,
DS3XM-12).
DS3 A DS-3 line on a DS3-12, DS3N-12, DS3-12E, DS3XM-6, DS3XM-12,
DS3/EC1-48 card.
E1 An E1 line on a DS1/E1-56 card.
E1000F An E1000 Ethernet card (E1000-2, E1000-2G).
E100T An E100 Ethernet card (E100T-12, E100T-G).
EC1 Any EC-1 port (including EC1-12 card ports).
ENVALRM An environmental alarm port.
EQPT A card, its physical objects, and its logical objects as they are located in any of the
eight noncommon card slots. The EQPT object is used for alarms that refer to the
card itself and all other objects on the card including ports, lines, synchronous
transport signals (STS), and virtual tributaries (VT).
ESCON Enterprise System Connection fiber optic technology, referring to the following
TXP cards: TXP_MR_2.5G, TXPP_MR_2.5G. For more information about ESCON
alarms, refer to the “Alarm Troubleshooting” chapter in the
Cisco ONS 15454 DWDM Troubleshooting Guide.
EXT-SREF BITS outgoing references (SYNC-BITS1, SYNC-BITS2).
To Next Page
Loading...
