2 Cisco RV215W Wireless-N VPN Firewall
Welcome
Thank you for choosing the Cisco RV215W Wireless-N VPN Firewall.
This guide describes how to physically install your Cisco RV215W and
launch the web-based Device Manager.
Mounting the Cisco RV215W
Placement Tips
To prevent the firewall from overheating or being damaged:
• Ambient Temperature—Do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
•Air Flow—Be sure that there is adequate air flow around the firewall.
• Mechanical Loading—Be sure that the firewall is level and stable to
avoid any hazardous conditions.
Place the device on a flat surface so that it sits on its four rubber feet.
Cisco RV215W Features
Front Panel
Power Solid green when the device is powered on and
booted.
Flashes green when the device is booting or
loading the firmware.
USB Solid green when the USB dongle is recognized
and the USB drive is ready.
Flashes green every second when the USB
dongle is successfully connected to the Internet
Service Provider (ISP) and the port is receiving
and sending data.
Flashes every 3 seconds when an error is
detected and the USB dongle is not recognized.
Off when no USB device is connected.
To Next Page
Loading...
