Need help?Do you have a question about the Cisco Table Microphone Pro and is the answer not in the manual?
Guidance on planning table layout for microphone placement.
Overview of microphone components like mute button and light ring.
Refer to placement plan, measure and mark hole positions.
Procedure for drilling holes into the table surface.
Guide to orienting the adapter arrow for correct microphone direction.
Securing the cable cover for a clean installation.
Connecting multiple microphones to the network switch.
Configuring microphones using the touch controller settings.
Measure and mark adapter positions according to the plan.
Drill holes, noting the adapter center is offset from the hole.
Install the adapter next to the drilled hole.
Securing the cable cover for a clean installation.
Connect microphones to the network switch.
Configuring microphones using the touch controller settings.
Measure and mark adapter positions based on the placement plan.
Orient the adapter arrow according to microphone placement.
Route the cable in the desired direction for proper connection.
Securing the cable cover for a clean installation.
Connect microphones to the network switch.
Configuring microphones using the touch controller settings.
Instructions for removing the cable cover using a flat-head screwdriver.
Device compliance with FCC Rules Part 15.
Links to Cisco Webex and Project Workplace resources.
General| Brand | Cisco |
|---|---|
| Model | Table Microphone Pro |
| Category | Microphone |
| Language | English |
To Next Page
