Cisco Systems, Inc.
www.cisco.com
Cisco TelePresence IX5000 and IX5200
First-Time Setup
Published: December 10, 2014
Revised: May 10, 2017
This chapter describes the tasks you perform to set up your Cisco TelePresence IX system for the first
time and includes the following sections:
• Summary of Changes, page 2
• Immediate Software Upgrade Requirements, page 2
• Required First Time Power-On and Software Installation Procedure, page 3
• Resetting the Table Switch to Fix Issues with Touch 10 Controllers, page 5
• Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System, page 5
• Powering on the System and Enabling the Cisco TelePresence Administration Software GUI, page 7
• Configuring an IX5000 or IX5200 System With a Static Network Address, page 10
• Requirements for Auxiliary Displays, page 11
• Requirements for Whiteboards and Whiteboard Microphones, page 12
• Performing First-Time Setup, page 15
• Retrieving and Reading the Results of the Noise Level and Reverberation Tests, page 39
To Next Page
