Installing the Cable Runner
Page 24
© 2015 Cisco Systems, Inc. All rights reserved.
2
a. Slide the cable runner base into position under the lower center frame. b. Loosen the 6x hex screws
(3x per cable runner bracket) using a 6mm T-handle hex driver. Place the hex driver through the access
holes in the frame beam as required. c. Lower the runner brackets through the cutouts in the runner until
both brackets are resting on the lower part of the runner (not on the ribs).
a. Slide the cable runner into
position
b. Loosen 3x
screws on
each side
c. Lower the
brackets
To Next Page
Loading...
