Cisco TelePresence IX5200 - Page 26

Installing the Pillars, Crossbars, and Rear Kick Plate/Toe Cap
Page 26
© 2015 Cisco Systems, Inc. All rights reserved.
Required Parts
Pillars:
• 4x 700-43514-xx (inside, outside, 2x center)
• 2x 700-43515-xx (far center-right and center-left)
• 2x 700-43516-xx (near center-right and center-left)
• 32x Black M4 X 12mm long screws with external lock washer 69-2797-xx
Crossbars:
• 3x crossbar pieces (700-43519-xx left, 700-43517-xx center, 700-43518-xx
right)
• 16x Black M4 X 12mm long screw with external lock washer 69-2797-xx
Rear kick plates:
• 3x Center, left, and right rear kick plates (center 700-43100-xx, left 700-43101-
xx, right 700-43099-xx)
• 6x M4 nut with lock washer 69-2793-xx
• 1x Cardboard spacer no part number, attached to the cable runner base
Rear toe caps:
• 3x Center, left, and right toe caps (center 700-43094-xx, left 700-43095-xx,
right 700-43093-x x)
• 10x M4 nut with lock washer 69-2793-xx
Required Tools
• Crossbar: #2 Phillips screwdriver
• KickPlateandToeCap:7mm Hex Driver
• KickPlateonly:cardboard spacer
Installing the Pillars, Crossbars, and Rear Kick Plate/Toe Cap