Installing the Pillars, Crossbars, and Rear Kick Plate/Toe Cap
© 2015 Cisco Systems, Inc. All rights reserved.
Page 27
1
Install the pillars (4x 700-43514-xx, 2x 700-43515-xx, 2x 700-43516-xx) into the frame by aligning the
tabs in the pillars into the slots on the frame. Attach the pillars to the frame with 32x M4 X 12mm screws
69-2797-xx (4x for each pillar) using a #2 Phillips screwdriver.
4x 69-2797-x x
Tab
Tab
Tab
700-43514-xx
700-43515-x x
700-43516-x x
2x 700-43514-xx
700-43516-x x700-43514-xx
700-43515-x x
To Next Page
Loading...
