Cisco TelePresence IX5200 - Page 49

Starting Installation and Cabling of the Front Row Table
© 2015 Cisco Systems, Inc. All rights reserved.
Page 49
Required Tools
• #3 and #4 Phillips Driver
• 13mm wrench or adjustable wrench
• 19mm 12-point ratcheting box end wrench
• Metric tape measure or ruler
• Spirit level
• Laser level
• 1/4-inch nut driver or wrench (for Power/Ethernet brackets)
Cables - First Row Table
CTS-5K-CBL-R1-SW (69-2669-xx), includes 1x 5 meter Ethernet
cable 37-1534-xx
CTS-5K-CBL-R1-LAP (69-2671-xx), Ethernet connectivity modules,
includes
• 1x 5 meter Ethernet cable 37-1561-xx EX1
• 6x 8 meter Ethernet cable 37-1562-xx, C1-C6
CTS-5K-CBL-R1-MIC (69-2674-xx), includes 6x DisplayPort-to-
DisplayPort cable, 2.6 meter, 37-1542-xx A1-A6
CTS-5K-CBL-R1-AC 69-2676-xx power cables, includes:
2x Jumper cable, 3 meter, 37-0833-xx D1 and D6
2x Jumper Cable, 2 meter, 37-0994-xx no reference designator -
extra jumper cables for middle legs
Required Parts
Table legs (1x left inside table leg 800-44195-xx, 1x right inside table leg
800-41001-xx, 2x outside table leg 800-41002-xx)
Ethernet/Power modules:
• 6x Power/Ethernet connectivity modules (part varies by country)
• 4x Power/Ethernet connectivity cover 700-47772-xx
• 2x Power/Ethernet connectivity blanking plates 700-45421-xx
• 20x #4-40 nuts for power/Ethernet connectivity brackets
1x Front Row Cable Management Assembly 800-40845-xx 49-0326-xx
14x M8x16mm screws 69-2792-xx
6x M6 nuts 69-2800-xx
2x Table leg connectors (700-44718-xx right, 700-44719-xx left)
8x M6x10mm screws 69-2803-xx
4x Cosmetic leg brackets (700-46219-xx far right, 700-44754-xx right-
center, 700-44755-xx left-center, 700-46218-xx far left)
2x jumper cables 37-0833-xx
1x PoE Switch WS-C2960C-8PC-L
2x switch bracket 700-44758-xx
2x #10-32 screws 69-100184-xx
1x Microphone Connector (MC) 800-40951-xx
Velcro cables 52-0449-xx as needed
Starting Installation and Cabling of the Front Row Table