Starting Installation and Cabling of the Front Row Table
Page 50
© 2015 Cisco Systems, Inc. All rights reserved.
1
Unpack the two table legs 800-41001-xx and 800-44195-xx and make sure that the top plate is
correctly installed. If the plates are incorrectly installed, remove the three screws that attach the plate to
the leg, flip it 180 degrees, then re-install it.
Correct - Cloverleaf pattern
on plate matches with slot
on table leg
Incorrect - Long slot on plate matches with slot
on table leg. Remove the three screws, ip plate
180 degrees, and reattach
800-41001-xx and
800-44195-x x
To Next Page
Loading...
