Installing and Cabling the Displays
Page 76
© 2015 Cisco Systems, Inc. All rights reserved.
3
Insert the spool on the right display. a. remove one M8 screw on the lower right side (when viewed
from the FRONT) of the display using a #3 Phillips driver. b. Install a silver M8 lock washer (part of 69-
2625-xx) and an M8 stud (part of 69-2625-xx). c. Tighten the stud with a 13mm wrench. d. Install the spool
(part of 69-2625-xx) on the threaded stud. d. MAKE SURE THAT THERE IS is 1 1/8 inch (29mm) distance
between the spool and the rear of the display or you cannot install the display.
69-2625-xx
1 1/8” (29 mm)
To Next Page
Loading...
