Cisco TelePresence MX700

12
Fasten right monitor and connect power cable
78-100254-03A0 | 2016 JUNE | © 2016 Cisco Systems, Inc. All rights reserved.
Installation guide for Cisco TelePresence MX700 Single camera - Wall mount
Page 16
Right side of the
monitor, viewed
from underneath
Left side of the
monitor, viewed
from underneath
Rear view
Enter the following screws:
• Four M6x35 screws, from front.
• Two M6x90 screws, from underneath.
• Two M6x100 screws and their brackets, from
underneath.
Then, tighten all screws.
Connect power cable
Connect the loose end of the power cable from
step 10 to the close-by socket at the rear of the right
monitor. The socket must be reached from below.
Make sure that the power switch next to the socket is
in its ON position.
1
2
2 × M6x90, countersunk
4 ×
M6x35, countersunk
2 ×
M6x100, pan
2 ×
Bracket