Cisco TelePresence System Codec C-Series Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 51
Cisco TelePresence System Codec C40/C60 API Reference Guide
xConfiguration Network [1..1] TrafficControl Mode
Set the network traffic control mode to decide how to control the video packets transmission speed.
Requires user role: ADMIN
Value space: <Off/On>
Off: Transmit video packets at link speed.
On: Transmit video packets at maximum 20 Mbps. Can be used to smooth out bursts in the
outgoing network traffic.
Example:
xConfiguration Network 1 TrafficControl: On
xConfiguration Network [1..1] RemoteAccess Allow
Filter IP addresses for access to ssh/telnet/HTTP/HTTPS.
Requires user role: ADMIN
Value space: <S: 0, 255>
Format: String with a maximum of 255 characters, comma separated IP adresses or IP range.
Example:
xC on fig u rat io n N etw ork 1 R e m ot e Ac c ess A llow: "192.168.1.231, 192.168.1.182"
xConfiguration Network [1..1] VLAN Voice Mode
Set the VLAN voice mode. The VLAN Voice Mode will be set to Auto automatically if you choose
Cisco UCM (Cisco Unified Communications Manager) as provisioning infrastructure via the
Provisioning Wizard on the Touch screen control panel.
Requires user role: ADMIN
Value space: <Auto/Manual/Off>
Auto: The Cisco Discovery Protocol (CDP), if available, assigns an id to the voice VLAN. If CDP is
not available, VLAN is not enabled.
Manual: The VLAN ID is set manually using the Network VLAN Voice VlanId setting. If CDP is
available, the manually set value will be overruled by the value assigned by CDP.
Off: VLAN is not enabled.
Example:
xConfiguration Network 1 VLAN Voice Mode: Off
xConfiguration Network [1..1] VLAN Voice VlanId
Set the VLAN voice ID. This setting will only take effect if VLAN Voice Mode is set to Manual.
Requires user role: ADMIN
Value space: <1..4094>
Range: Select a value from 1 to 4094.
Example:
xConfiguration Network 1 VLAN Voice VlanId: 1
NetworkPort configuration
xConfiguration NetworkPort [2] Mode
Define if the network port 2 shall be enabled for direct pairing with a Cisco TelePresence Touch
screen control panel.
NOTE: Restart the system for any change to this setting to take effect.
Requires user role: ADMIN
Value space: <Inactive/DirectPairing>
Inactive: Set the NetworkPort 2 to Inactive when no device is connected.
DirectPairing: Set the NetworkPort 2 to DirectPairing when you have a Cisco TelePresence Touch
screen control panel connected to the port. This will enable for direct pairing between the Touch
screen control panel and the codec.
Example:
xConfiguration NetworkPort 2 Mode: Inactive
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xConfigu ration

Cisco TelePresence System Codec C-Series Specifications

General

Brand	Cisco
Model	TelePresence System Codec C-Series
Category	Conference System
Language	English