Cisco TelePresence System Profile Series Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 134
Cisco TelePresence System Codec C40/C60 API Reference Guide
xCommand Video Layout Assign
NOTE: This command is not supported on Codec C40.
Assign an existing layout to any local or remote output. The defined video composition appears on
the specified local output or in the specified remote video stream.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is
run. During the call you can run the xStatus Call command to see the CallId.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout
Add command was issued.
Requires user role: ADMIN
Parameters:
CallId(r): <0..65534>
OutputId(r): <0..65534>
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout Assign CallId:1 OutputId:1 LayoutId:2
OK
*r VideoLayoutAssignResult (status=OK):
** end
xCommand Video Layout AssignLocalOutput
NOTE: This command is not supported on Codec C40.
Assign an existing layout to a local output. The defined video composition appears on the specified
local output.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout
Add command was issued.
OutputId: A unique identifier for the local output, which was created when the xCommand Audio
LocalOutput Add command was issued.
Requires user role: ADMIN
Parameters:
LayoutId(r): <1..2147483647>
OutputId(r): <0..65534>
Example:
xCommand Video Layout AssignLocalOutput OutputId:1 LayoutId:2
OK
*r VideoLayoutAssignLocalOutputResult (status=OK):
** end
xCommand Video Layout AssignCall
NOTE: This command is not supported on Codec C40.
Assign the call layout (main stream) to the remote output. The defined video composition appears
on the remote main video stream.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout
Add command was issued.
CallId: A unique identifier for the call. The CallID is returned when the xCommand Dial command is
run. During the call you can run the xStatus Call command to see the CallId.
Requires user role: ADMIN
Parameters:
LayoutId(r): <1..2147483647>
CallId: <0..65534>
Example:
xCommand Video Layout AssignCall LayoutId:2 CallId:1
OK
*r VideoLayoutAssignCallResult (status=OK):
** end
xCommand Video Layout AssignPresentation
NOTE: This command is not supported on Codec C40.
Assign the presentation layout (dual stream) to the remote output. The defined video composition
appears on the remote dual video stream. This layout must be full-screen and contain only one
frame.
LayoutId: A unique identifier for the layout, which was created when the xCommand Video Layout
Add command was issued.
Requires user role: ADMIN
Parameters:
LayoutId(r): <1..2147483647>
Example:
xCommand Video Layout AssignPresentation LayoutId:2
OK
*r VideoLayoutAssignPresentationResult (status=OK):
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence System Profile Series Specifications

General

Brand	Cisco
Model	TelePresence System Profile Series
Category	Conference System
Language	English