Cisco TelePresence System Profile Series Reference Guide

D14642.15 Codec C40-C60 API Reference Guide TC7.0, JANUARY 2014. Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved. 89
Cisco TelePresence System Codec C40/C60 API Reference Guide
*r AudioEqualizerListResult Equalizer 1 Section 4 Q: "4"
*r AudioEqualizerListResult Equalizer 1 Section 4 Gain: "0"
*r AudioEqualizerListResult Equalizer 1 Section 5 FilterType: "Peaking"
*r AudioEqualizerListResult Equalizer 1 Section 5 Frequency: "2000"
*r AudioEqualizerListResult Equalizer 1 Section 5 Q: "4"
*r AudioEqualizerListResult Equalizer 1 Section 5 Gain: "0"
*r AudioEqualizerListResult Equalizer 1 Section 6 FilterType: "Peaking"
*r AudioEqualizerListResult Equalizer 1 Section 6 Frequency: "5000"
*r AudioEqualizerListResult Equalizer 1 Section 6 Q: "0"
*r AudioEqualizerListResult Equalizer 1 Section 6 Gain: "0"
** end
xCommand Audio Microphones Mute
Mute all microphones.
Requires user role: USER
Example:
xCommand Audio Microphones Mute
*r AudioMicrophonesMuteResult (status=OK):
** end
xCommand Audio Microphones Unmute
Unmute microphones.
Requires user role: USER
Example:
xCommand Audio Microphones Unmute
*r AudioMicrophonesUnmuteResult (status=OK):
** end
xCommand Audio LocalInput Add
Create a local input and generate the local input id. A local input is a mix of input connectors with
the following settings: Name, MixerMode, AGC, Mute and Channels.
InputId: A unique identifier for the local input.
Name: Choose a name that describes the mix of input connectors.
MixerMode Auto: The microphone with the strongest speaker is active and the others are strongly
attenuated.
MixerMode Fixed: The input connector signals are mixed together with equal gains.
MixerMode GainShared: The microphones are given a normalized gain factor relative to the
strongest speaker before being mixed together.
AGC: Automatic Gain Control.
Mute: Mutes the mix of input connectors.
Channels: Set channels to 1 to mix the input connectors into a mono signal. To mix the input
connectors into a stereo signal, set channels to 2.
Requires user role: ADMIN
Parameters:
InputId: <0..65534>
Name: <S: 0, 255>
MixerMode: <Auto/Fixed/GainShared>
AGC: <On/Off>
Mute: <On/Off>
Channels: <1..2>
Example:
xCommand Audio LocalInput Add
OK
*r AudioInputGroupAddResult (status=OK):
InputId: 2
** end
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand

Cisco TelePresence System Profile Series Specifications

General

Brand	Cisco
Model	TelePresence System Profile Series
Category	Conference System
Language	English