Need help?Do you have a question about the Cissell MUMAN196 and is the answer not in the manual?
Details the initial assembly steps for the rear of the press.
Explains how to assemble the table components and attach them.
Guides the assembly of the iron rest plate and related parts.
Instructions for mounting the optional tail board to the press table.
Details how to connect steam and vacuum lines to the press.
Illustrates the recommended piping configuration for steam and irons.
Lists part numbers for various groups of press components.
Exploded view and parts list for the press frame assembly.
Exploded view and parts list for the trip lever mechanism.
Exploded view and parts list for the back lever mechanism.
Exploded view and parts list for the head lever assembly.
Exploded view and parts list for the balance spring assembly.
Exploded view and parts list for the connecting leverage system.
Exploded view and parts list for the pivot shaft assembly.
Exploded view and parts list for the press shoe group.
Exploded view and parts list for the oil check assembly.
Diagram illustrating steam connection points on the press.
Exploded view and parts list for the head valve assembly.
Exploded view and parts list for the buck valve unit.
Exploded view and parts list for the air vacuum valve assembly.
Details how to adjust various components of the press for optimal performance.
Adjusting the head lever for proper pressure and finish.
Adjusting the trip lever for setting the locking point.
Adjusting the head valve to meter head steam flow.
Adjusting the buck steam linkage for steam flow.
Adjusting the buck valve for steam.
Adjusting balance springs for closing force and opening speed.
Adjusting the oil check assembly.
Troubleshooting steps when the press head fails to lock.
Addressing issues where the press head is difficult to close.
Resolving problems related to the press head banging upon release.
Troubleshooting steps when there is no vacuum.
Diagnosing why the vacuum does not shut off properly.
Adjusting the buck steam valve for correct steam output.
Troubleshooting wet spots on the buck pad and covering.
Troubleshooting wet spots on the head pad and covering.
Identifying and fixing external leaks from the buck valve.
Diagnosing and repairing external leaks from the head valve.
Troubleshooting issues related to the absence of head steam.
To Next Page
General