EasyManua.ls Logo

citEcar Bubble Buddy - Page 27

Default Icon
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
1D – per day 1W – per week 1M – per month 1Q – per quarter 1Y – per year
item Descriptions 1D
1W
1M 1Q 1Y
Battery
1. Check the liquid level. Please add the distilled water if
necessary.
Y
2. Charge the battery Y
3. Tighten the nut on the battery cable Y
4. Check if the battery is over-discharged (the battery power
meter is flashing)
Y
5. Check the liquid density of the battery, standard density
should be 1.270.007g/ cm
3
(80
o
F. or 25) when the battery is
fully charged.
Y
6. Check to see if the battery is charged fully by 2 ways: a) using
the hydrometer; b) checking the battery power meter
Y
7. Clean the surface of the battery Y
Charger
8. Observe the charging status, check if the charger plug
becomes hot.
Y
9. Clean the surface of the charger. Do not get any water inside
the charger.
Y
Controller
10. Check to see if all terminals are tightened properly. Please
do this after the power is off.
Y
11. Clean the surface of the controller. Y
12. Check if the solenoid is in order, by checking its touching
point.
Y
Motor
13. Check if any water got in. Check if it becomes too hot. Y
14. Check to see if the carbon brush should be replaced. Y
15. Check to see if the accelerator pedal works well and if it can
be released freely and automatically.
Y
Chassis
and body
16. Check to see if the brake drum and the brake shoe should
be replaced or not.
Y
17. Check to see if the hand brake functions. (Applicable for
vehicle with hand brake).
Y
18. Check to see if the line for the brake fluid is leaking.
(Applicable for vehicle with hydraulic brake).
Y
19. Check to see if the brake fluid inside the brake fluid tank is
enough. (Applicable for vehicle with hydraulic brake).
Y
20. Check the air pressure inside the tire, check to see if the tire
surface is worn, and check if the nuts are tightened properly.
Y
21. Check to see if the shock absorber has any oil leaking, is flat
or is making any abnormal noise.
Y
22. Check to see if there is oil leaking on the gear box and the
rear end.
Y
23. Add the lubricant inside the wheel hub, steering system. Y
24. Adjust the toe-in of the front end Y
25. Clean the body and seat Y
After above maintenance, drive the vehicle to check if the vehicle works properly.