D. Dive Time Alarm
What is the dive time alarm?
If a certain period of time was previously set for diving, a buzzer sounds
for 30-40 seconds when the diver stays in the water beyond the set time.
To stop the buzzer, push either the (S)(upper left), (R)(upper right) or
(M)(lower left) buttons.
However, diving time at a depth of 1m(3ft) or less cannot be measured.
•
With each push of the (R)(upper right)
button, the time advances 5 minutes. Quick
forwarding is obtained by pressing and
holding the (R)(upper right) button.
•
The dive time alarm can be set at 60 minute
in intervals of 5 minutes.
Every second on the second, the alarm sounds
for 1/8 second. Moreover, it repeatedly
sounds for 1/8 second at intervals of 1/8
second. This remains in affect for 30-40
seconds.
E. Depth Meter
What is the Depth Meter?
It is a function of measuring the depth of a dive.
When measuring a depth of more than 1m (3ft), the depth meter mode is not
replaced by any other mode even when the (S)(upper left) button is pushed
(fail safe operation.)
How to read the display
•
The maximum display value of the dept meter is 80m
(260ft)
•
Depth is displayed as follows;
<Display in meters> 0->1.0->1.1->1.2->.->80.0
<Display in feet> 0->3->4->5->…260->----
•
When the figure (0) is displayed, it flashes
•
If the figure (0) remains displayed for 30-40 minutes,
the display will automatically return to the maximum
memory mode (automatic return).
F. Dive Time Reading
What is dive time reading?
•
It is a function of measuring the dive time at a depth of more than
1m(3ft)
•
This measurement automatically starts at a depth of more than 1m(3ft) and
automatically stops at a depth of less than 1m(3ft)
How to read the display
•
When the depth meter mode is 0m(0ft), the dive time
reading is not carried out.
•
Up to 59 min, 59 sec. Of dive times is measured at
intervals of 1 second
After measuring 59 min, 59 sec, the measurement starts
again from 00 min,00 sec.
Return to Table of Contents
Return to Table of Contents
To Next Page
Loading...
Need help?
General
