BT
Measurement is begun, but the pressure was insufficient.
DISPLAY MARK
CONDITION/CAUSE CORRECTIVE ACTION
Ask purchased shop.
Replace the batteries.
Repeat measurement again.
First, exhaust air from the cuff, reapply the cuff prop-
erly and remeasure.
Repeat measurement again.
Repeat measurement again.
Device has a trouble.
Appears when the batteries become weak.
Appears when the pulse could not be measured.
Appears when the blood pressure could not be measured accu-
rately.
(Some noises were detected by the movement of arm during
measurement).
DESCRIPTION OF DISPLAY MARKS
- Eng 10 -
To Next Page
