- Eng 19 -
English
HOW TO MEASURE YOUR BLOOD PRESSURE
Normally, the measurement results are automatically stored. If you
don’t want to store the measurement results, erase them
immediately after measurement according to the procedure below.
* Once stored, measurement results cannot be cleared individually.
1
Press and hold for more than 2
seconds while the measurement
results are displayed.
The message for memory clearance (CL) will
appear, and the device will automatically turn off
the power in 2 seconds.
* This step will permanently delete the
measurement results being displayed so that you
cannot undo this action to call up them later.
Before proceeding, make sure that you want to
delete them.
IF YOU DO NOT WISH TO STORE MEASUREMENT RESULTS
To Next Page
Loading...
