176
Practical information
stations equipped with AdBlue
®
pumps specially
designed for passenger vehicles.
Recommendations on storage
AdBlue
®
freezes at about -11°C and deteriorates
above +25°C. Containers should be stored in a
cool area and protected from direct sunlight.
Under these conditions, the uid can be kept for
at least a year.
If the uid has frozen, it can be used once it has
completely thawed out at room temperature.
Never store AdBlue
®
containers in your
vehicle.
Precautions for use
AdBlue
®
is a urea-based solution. This uid is
non-ammable, colourless and odourless (when
kept in a cool place).
In the event of contact with the skin, wash the
aected area with soap and running water. In the
event of contact with the eyes, immediately rinse
the eyes with large amounts of water or with an
eye wash solution for at least 15 minutes. Seek
medical attention if you feel a persistent burning
sensation or irritation.
If swallowed, immediately wash out the mouth
with clean water and then drink plenty of water.
In certain conditions (high temperature, for
example), the risk of release of ammonia cannot
be excluded: do not inhale the uid. Ammonia
vapours have an irritant eect on mucous
membranes (eyes, nose and throat).
Store AdBlue
®
out of the reach of
children, in its original container.
Procedure
Before starting the top-up procedure, ensure that
the vehicle is parked on a at and level surface.
In wintry conditions, ensure that the temperature
of the vehicle is above -11°C. Otherwise the
AdBlue
®
may be frozen and so cannot be poured
into the tank. Park the vehicle in a warmer area
for a few hours to allow the top-up to be carried
out.
Never pour the AdBlue
®
into the Diesel
fuel tank.
If any AdBlue
®
is splashed, or if there are
any spillages on the bodywork, rinse
immediately with cold water or wipe with a
damp cloth.
If the uid has crystallised, clean it o using a
sponge and hot water.
Important: in the event of a top-up after
a breakdown because of a lack of
AdBlue, it is essential to wait around 5
minutes before switching on the ignition,
without opening the driver’s door,
unlocking the vehicle, inserting the key
into the ignition switch, or bringing the
key for the "Keyless Entry and Start"
system into the passenger compartment.
Switch on the ignition, then wait for 10
seconds before starting the engine.
► Switch o the ignition and remove the key
from the switch to switch o the engine.
or
► With Keyless Entry and Start, press the
"START/STOP" button to switch o the engine.
► Turn the blue cap of the AdBlue
®
tank anti-
clockwise and remove it.
► With a container of AdBlue
®
: after checking
the expiry date, read the instructions on the
label carefully before pouring the contents of the
container into the vehicle's AdBlue
®
tank.
► With an AdBlue
®
pump: insert the nozzle and
ll the tank until the nozzle automatically cuts
out.
In order not to overll the AdBlue
®
tank:
– Add between 10 and 13 litres using
AdBlue
®
containers.
– Stop after the nozzle’s rst automatic cut-
out, if you are relling at a service station.