201
Practical information
DS5_en_Chap08_info-pratiques_ed02-2015
Removing the cartridge
F Stow the black pipe.
F Detach the angled base from the white pipe.
F Support the compressor vertically.
F Unscrew the cartridge from the bottom.
Beware of discharges of fluid.
The expiry date of the fluid is indicated
on the cartridge.
The sealant cartridge is designed for
single use; even if only partly used, it
must be replaced.
After use, do not discard the cartridge
into the environment, take it to an
authorised waste disposal site or a
CITROËN dealer.
Do not forget to obtain a new sealant
cartridge, available from CITROËN
dealers or from a qualified workshop.
Checking tyre pressures /
inflating accessories
You can also use the compressor, without
injecting any product, to:
- check or adjust the pressure of your tyres,
- inflate other accessories (balls,
bicycle tyres...).
F Turn the selector A to
the "Air" position.
F Uncoil the black pipe H fully.
F Connect the black pipe to the
valve of the wheel or accessory.
If necessary, fit one of the adaptors
supplied with the kit first.
F Connect the compressor's electrical
connector to the vehicle's 12 V socket.
F Start the vehicle and let the engine run.
F Adjust the pressure using the compressor
(to inflate: switch B in position "I";
to deflate: switch B in position "O" and
press button C), according to the vehicle's
tyre pressure label or the accessory's
pressure label.
F Remove the kit then stow it.
To Next Page
Loading...
