Need help?Do you have a question about the CITROEN Amicale 5 HP and is the answer not in the manual?
General| Brand | CITROEN |
|---|---|
| Model | Amicale 5 HP |
| Category | Automobile |
| Language | English |
Discusses the choice between magneto and Delco ignition systems for the 5HP car.
Explains how to set the engine ignition timing at Top Dead Center (TDC) for compression.
Details how to adjust magneto or distributor contacts for proper spark and clean contacts.
Describes how to check the breaker contact setting for accurate ignition timing.
Provides essential maintenance tips and precautions for the ignition system components.
Explains how to set the angle transmission and distributor for ignition timing.
Discusses common vibrations originating from the gearbox flector and their causes.
Details fuel filtration, decanters, and safety checks for the fuel supply system.
Covers fuel tank rust removal and chemical treatment for preservation.
Advises on selecting appropriate gasoline and its effects on fuel lines.
Discusses the use of additives and engine oil in gasoline for 5 HP cars.
Details lubrication and adjustment of the steering box, including potential play.
Addresses steering vibrations and play by checking and adjusting ball joints.
Covers battery level checks, charging methods, and maintenance for optimal performance.
Discusses spark plug selection, thermal choices, and gap settings for ignition.
Explains starter lubrication, maintenance, and troubleshooting common issues like sticking.
Details dynamo lubrication, brush checks, and adjustments for charging the battery.
Advises on inspecting, redoing, and protecting the electrical wiring harness for fire prevention.
Covers clutch lubrication, adjustment for slipping, and release bearing play for proper operation.
Details how to adjust the brake control rods and ensure proper lining contact.
Provides useful tips regarding brake linings, drums, and linkage geometry.
Explains the correct procedure and torque for tightening cylinder head nuts.
Discusses descaling cylinder heads and blocks using hydrochloric acid for cleaning.
Covers methods for repairing cracks in cylinder heads or blocks, including welding and sealants.
Advises on selecting the correct type of oil for the engine based on its condition.
Details how to check and maintain the correct engine oil level using the dipstick and tap.
Offers a tip to improve the engine oil pump flow rate for better lubrication.
Discusses methods to improve lubrication of the engine's distribution system.
Recommends chassis lubrication intervals and types of grease fittings to use.
Specifies correct tire pressures for different types of tires fitted to the 5 HP.
Covers checking rear axle oil level and its importance for durability.
Addresses the replacement of fragile rear axle shafts and potential part shortages.
Suggests methods to improve the engine's cooling system efficiency.
Explains how to check and maintain the coolant level in the cooling circuit.
Details the procedure for adjusting engine valve clearances.
Explains the process of grinding valves and seats for proper sealing.
Addresses common issues with collapsed leaf springs and their re-arching.
Explains how to check and adjust front axle parallelism (toe-in).
Describes checking the front wheel camber angle and its importance for stability.
Details how to check and adjust the front axle castor angle for steering stability.
Details crankshaft balancing for vibration reduction and oil spoon function in connecting rod bearings.
To Next Page